BIQU Panda Jet Pack V2.0 Transparent Shell 3D Printer Accessory
- Panda Jet Pack V2 T…
- US7-1060000840
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Extends the BL auto-leveling cable by 1.5 metres for CR-10 and Ender-3 printers
This 1.5 metre extension cable connects a BL Touch sensor to the mainboard on Creality CR-10 and Ender-3 printers. It replaces the stock cable when the sensor is mounted further from the board or routed through a cable chain. The part is intended for owners adding or relocating automatic bed levelling on these machines.
The cable uses a plastic sheath and moulded plugs that slot directly into the BL Touch probe and the printer mainboard without soldering. The 1.5 metre length gives enough slack for full gantry travel on the target printers while keeping the routing tidy. The durable plastic construction resists fatigue from repeated motion during long prints.
The upgrade is worthwhile when the original cable is too short for a relocated sensor, a direct-drive conversion or a custom enclosure. It is not for printers that use a different probe connector pinout or for users who need a shorter run to avoid excess cable drag.
Measured against everything we stock in 3D Printing Accessories & Materials, at today’s prices. Recalculated every night.
New to this? Buying a printer and toner with crypto — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
The 1.5 m cable reaches from the BLTouch probe to the mainboard on standard CR-10 and Ender-3 frames without stretching or needing an extra extension.
The plastic bracket uses the existing M3 holes on the print-head carriage; no new holes or adapters are required.
Plug the 3-pin connector into the BLTouch port on the mainboard and the 2-pin end into the probe; the step many forget is flashing firmware with BLTouch enabled before the first print.
More in 3D Printing Accessories & Materials
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?