BIQU Panda Jet Pack V2.0 Transparent Shell 3D Printer Accessory
- Panda Jet Pack V2 T…
- US7-1060000840
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Precise limit switch and cable set for Ender-3, Pro, CR10, 10S and 10PRO printers, ensuring accurate positioning
This limit-switch and cable set fits Ender-3, Ender-3 Pro, CR-10, CR-10S and CR-10 Pro printers. It supplies the X, Y and Z axis endstops in a single kit. The parts are intended for hobbyists, repair shops and anyone maintaining or building those machines.
Each switch is a simple mechanical contact that signals the printer firmware when an axis reaches its travel limit. The cables carry only the switch signal; they do not transmit power to the stepper motors. Wiring must match the printer board pin-out to avoid a short or an open circuit.
Verify that your control board uses the same three-pin connector layout as the original Creality boards. Confirm which axis you are replacing because the kit is sold as a complete X, Y, Z set. Ensure you have basic hand tools and access to the printer frame for installation.
Measured against everything we stock in 3D Printing Accessories & Materials, at today’s prices. Recalculated every night.
New to this? Buying a printer and toner with crypto — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
Choose the X, Y or Z option that matches the axis you are replacing on an Ender-3, Ender-3 Pro, CR-10, CR-10S or CR-10PRO.
The switch provides precise positioning so the printer homes each axis reliably, giving consistent first-layer adhesion and repeatable layer alignment.
The cable plugs directly into the printer’s mainboard endstop header and carries the signal that stops each stepper motor at the axis limit.
More in 3D Printing Accessories & Materials
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?