Darkside Computer Modding 3-Pin 50cm Fan Sleeved Cable Jet Black DS-0518
A 50 cm sleeved 3-pin fan extension cable in jet black for tidy internal routing
- Cable length1.62 ft (0.49 m)
- Extends fan reach with 50 cm sleeved cable
- Jet black finish keeps wiring discreet inside the case
- 3-pin male-to-female connector fits standard fan headers
- 62 ft length suits most mid-tower builds
- DS-0518 model identifies the exact part for reordering
Purpose and Audience
The Darkside 3-Pin 50cm Fan Sleeved Cable is a short internal power lead built for PC builders who need to route a standard three-pin fan connector to a nearby motherboard header or fan controller. It suits compact cases and tidy cable-management jobs where excess length would create clutter.
Deciding Specification
The cable carries a three-pin fan connector at each end in a male-to-female arrangement, so it only works with fans and headers that use the three-pin layout. Builders whose fans or motherboard headers require a four-pin PWM connector cannot use this cable.
Capacity and Headroom
At 50 centimetres the cable comfortably bridges short runs between a chassis fan mount and a neighbouring header. It runs out when the distance exceeds that length or when a four-pin PWM signal is needed for automatic speed control.
How it compares
Measured against everything we stock in Internal PSU & Riser Cables, at today’s prices. Recalculated every night.
- Price $1.99
- Cheaper than about 98% of the 7,693 comparable items (median $14.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
| Size & build | |
|---|---|
| Cable length | 1.62 ft (0.49 m) |
Questions about this item
How much reach does the 50 cm cable add between a fan header and the fan?
The 50 cm length gives roughly 19.5 inches of extra reach so a 3-pin fan can sit farther from the motherboard header without tension.
What does the 3-pin connector limit compared with a 4-pin PWM header?
A 3-pin connector carries power, ground and a tachometer signal but lacks the fourth PWM wire so the motherboard can only vary voltage not duty-cycle control.
Will the 50 cm sleeved cable fit behind a standard motherboard tray?
At 50 cm the cable is long enough to route behind most ATX motherboard trays and still reach rear or top-mounted fans with slack for cable ties.
More in Internal PSU & Riser Cables
Similar items
Darkside Computer Modding DS-0819 Molex 4-pin to dual 3-pin Y-cable 12V 30cm Black
- Black
- Simple power Y-cabl…
Lian Li PW-PCI-520X PCIe 5.0 riser cable 200 mm
- PCIe 5.0 Riser Cable
- Black
Darkside Computer Modding CONNECT Pass-Through Cable 12" 3-Pin Type 3
- 1 ft (0.3 m)
Silverstone Technology PP14-PCIE 2x PCIe 8-pin to 12VHPWR internal power cable
- 2x PCIe 8pin female
- 1x 12VHPWR PCIe Gen…
Darkside Computer Modding CONNECT 3-Way Molex Splitter Cable 4 in DS-0395
- 4 in (10.2 cm)





