Arctic Silver AS5-3.5G thermal paste 3.5g tube
- 3.5g
- -50 to 130 °C
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Thermal pad sized 120 by 120 by .5 mm fills gaps on uneven components like memory ICs and MOSFETs for high-conductivity heat transfer
The GELID SOLUTIONS GP-Extreme is a 0.5 mm thick thermal pad designed to bridge height differences on graphics cards, motherboards and other PCBs. Its soft construction conforms to memory ICs, MOSFETs and micro-controllers to transfer heat efficiently to a heatsink. The 120 x 120 mm sheet can be cut to fit multiple components. It is a single-use interface that compresses permanently on installation.
Measure the distance between the component top and the heatsink base to confirm a 0.5 mm pad fills the void without excessive pressure. Verify that the mating surfaces are clean and free of old compound residue. Remember that both protective films must be removed before placement, and the pad cannot be reused once compressed.
This pad upgrades from basic silicone sheets when lower thermal resistance is needed for high-load components. The jump is worthwhile when stock pads run too hot or leave air gaps on uneven SMD layouts. It is not suited for large, flat dies that require thin paste or for gaps thicker than the specified 0.5 mm.
Measured against everything we stock in Thermal Paste, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
No published specifications for this item yet.
The pad measures 120 mm by 120 mm and is supplied as a single sheet; you can cut it to the exact shape required for your components.
The 0.5 mm thickness is suited for tight clearances between the heatsink and low-profile chips such as memory ICs or MOSFETs.
The 12 W/m·K conductivity rating means the pad transfers heat efficiently across the interface, lowering component temperatures when compressed between the chip and cooler.
More in Thermal Paste
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?