Apple MD565LL/A 60W MagSafe 2 Power Adapter
- AC Power
- 60 W, Input: 100-24…
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
Converts PCIe x8 Gen 4 to OCulink 8i with a built-in ReDriver for extended signal reach
This PCIe Gen4 adapter converts an OCulink 8i SFF-8612 connection to a PCIe x8 Gen 4 slot. It integrates a ReDriver to extend signal reach across longer traces and cables. A built-in 100 MHz clock buffer with 100 ohm impedance drives extended lengths. The green D1 LED indicates when the add-in card is ready.
The adapter follows SFF-9402 Rev 1.1 pin-out definitions for the OCulink 8i connector. It meets PCI Express Base Specification Rev 4.0 and PCIe CEM Spec R4.0 standards. An onboard SMBus switch at address 0xE2 manages four channels with reset for both OCulink SMBus and clock buffer control. PERST#, WAKE#, CLKREQ# and PWRBRK# buffer gates support longer cable runs.
The card supports PCIe bifurcation so a single x8 link can be split into multiple lanes for dense rack deployments. Operating system support covers Windows 8, 8.1, 10 and UEFI 2.3.1 or later firmware. No driver installation is required for the hardware conversion itself. The adapter is designed and made in Taiwan.
Measured against everything we stock in Other Adapters & Couplers, at today’s prices. Recalculated every night.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
| Product | |
|---|---|
| Adapter type | PCIe Gen4 |
The built-in ReDriver extends the PCIe 4.0 8-lane signal so the OCulink 8i device receives a clean high-speed link over longer cables.
The SFF-8612 connector follows SFF-9402 Rev 1.1 pin-out and is compliant with the PCI Express OCulink 1.0 a specification.
It mounts as a standard add-in card and uses the on-board PERST#, WAKE#, CLKREQ# and PWRBRK# buffers to maintain signal integrity over extended trace lengths.
More in Other Adapters & Couplers
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?