SATAGear SS-035RL SATA cable 14in right to left angle
A 14-inch internal SATA cable with right-to-left angled 7-pin connectors for tight drive bays
- Cable length1.16 ft (0.35 m)
- Right-to-left angled connectors simplify tight drive bays
- 14-inch length reaches motherboard ports without excess slack
- 0 Gbps transfer rate supports full SATA III bandwidth
- Shielded construction reduces EMI/RFI interference
- Narrow cable profile improves airflow inside the case
SATAGear SS-035RL SATA cable
This 14in SATA cable uses right-angle to left-angle connectors to fit tight drive bays and crowded motherboard headers. It carries Serial ATA signals up to 6.0 Gbps and meets the Serial ATA 1.0 standard. Shielded construction reduces EMI and RFI interference. The narrow profile simplifies routing and improves internal airflow.
Builders with cramped SATA ports.
The angled ends solve clearance problems where a straight plug would hit a drive cage, a graphics card or a case wall. Installers who need a straight-through cable or a different angle orientation should choose another design. This cable is intended for internal SATA hard drives, optical drives and other Serial ATA devices only.
Right-angle to left-angle connector orientation
The defining spec is the connector geometry: one end angles right (down) and the other angles left (up). That fixed orientation determines whether the cable reaches your specific port-and-drive layout without stress on the connectors. Cable length is 1.16 ft (14in).
How it compares
Measured against everything we stock in SATA & eSATA Drive Cables, at today’s prices. Recalculated every night.
- Price $0.65
- Cheaper than about 99% of the 1,954 comparable items (median $13.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
| Product | |
|---|---|
| Model name | SS-035RL |
| Size & build | |
| Cable length | 1.16 ft (0.35 m) |
Questions about this item
Does the SATA 6.0 Gbps cable support the full 6.0 Gbps transfer rate?
Yes, the cable is rated for data transfer rates up to 6.0 Gbps and meets Serial ATA 1.0 standards.
What clearance does the right-to-left angled connector need to fit?
The right-angle connector bends down and the left-angle connector bends up, allowing tight routing against the motherboard or drive chassis in a 14in length.
How do I install the dual 7-pin female connectors correctly?
Align the L-shaped key on each 7-pin female connector with the port notch, press straight in until seated, and route the shielded 1.16 ft cable without sharp bends.
More in SATA & eSATA Drive Cables
Similar items
Darkside DS-0761 10mm SATA cable sleeving 1ft Green
- Green
- Tired of your cable…
Nippon Labs SATA-1MR 1m right-angle SATA cable
- 3.28 ft (1m)
- SATA
SATACables LP30SR584 SATA cable 23 inch low profile straight to right
STARTECH SATA6RA1 6" SATA right-angle cable 26 AWG 152.4 mm
- 6 in (15.2 cm)
- Cable Connectors





