Vszerda IDE 40-pin to SATA Adapter 3.5" 1000GB
Connects 3.5 inch 40-pin IDE drives up to 1000GB to SATA motherboards with plug-and-play setup and no extra power needed
- Connect 3.5" IDE drives to SATA motherboards via 40-pin adapter
- Supports IDE 66/100/133MB/s transfer rates for legacy drives
- Works with IDE drives up to 1000GB capacity
- No driver installation required for DOS, Windows 98 through Windows 7 and Linux
- Jumper must be set to MASTER for proper operation
IDE 40-pin to SATA adapter for 3.5" drives
This adapter converts a 3.5 inch IDE or PATA 40-pin hard drive, CD-ROM or CD-RW to a SATA interface so it can connect to a modern motherboard. It supports drives up to 1000GB and works with DOS, Windows 98 through Windows 7 and Linux. No extra power supply or driver is required for operation.
Upgrades legacy IDE storage to SATA motherboards
The unit replaces a direct IDE connection when the board only offers SATA ports, letting you keep an existing 3.5 inch drive during a platform refresh. It handles IDE transfer modes at 66, 100 and 133MB/s and is intended for a permanent internal install rather than hot-swap use. The drive jumper must be set to MASTER or the adapter will not function.
Fits a desktop build with a free SATA port
Installation needs one spare SATA data connector on the motherboard and a standard drive power cable from the PSU. The adapter board itself is compact and plugs straight onto the drive’s 40-pin header, freeing the IDE cable and header for removal. It is not hot-swappable, so the system must be powered down to attach or detach the drive.
How it compares
Measured against everything we stock in SATA & eSATA Drive Cables, at today’s prices. Recalculated every night.
- Price $9.99
- Cheaper than about 70% of the 1,954 comparable items (median $13.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
No published specifications for this item yet.
Questions about this item
Does the 40-pin IDE connector fit a standard 3.5-inch drive bay?
The adapter is a 3.5-inch PCBA designed to mount directly onto the back of a 3.5-inch IDE hard drive or optical drive, aligning with its 40-pin interface.
What jumper setting is required on the IDE drive before connecting the adapter?
The IDE hard drive jumper must be set to MASTER; Cable Select or Slave settings will prevent the adapter from functioning.
Is any periodic maintenance or component replacement needed for the adapter itself?
The unit is a passive plug-and-play board with no moving parts, firmware, or consumable components, so it requires no scheduled maintenance or replacement.
More in SATA & eSATA Drive Cables
Similar items
BENFEI SATA III 6Gbps Cable 3-Pack 18 Inch Blue Locking Latch
- Sata
- SATA
STARTECH SATA6RA1 6" SATA right-angle cable 26 AWG 152.4 mm
- 6 in (15.2 cm)
- Cable Connectors
Nippon Labs SATA-1MR 1m right-angle SATA cable
- 3.28 ft (1m)
- SATA
Coolgear SS-AZX12MPSS SATA 12" Male-Female Extension Cable (7 Pin) Red
- Sata 7-pin
- SATA





