Vszerda Oculink SFF-8611 to U.2 U.3 SFF-8639 NVME cable 1.64FT
Connects an Oculink SFF-8611 host to a U.2 or U.3 NVMe drive at up to 12 Gbps over 1.64 ft
- PCIe 4.0 x4 support for fast NVME drives
- 12 Gbps data transfer keeps storage responsive
- Oculink SFF-8611 to U.2/U.3 SFF-8639 connector fit
- 64FT length gives flexible routing options
- SATA power included for reliable device operation
PCIe Gen 4 Oculink SFF-8611 to U.2 U.3 SFF-8639
This new cable connects a host Oculink SFF-8611 port to a U.2 or U.3 SFF-8639 NVMe device. It measures 1.64FT and includes a SATA power connector. The link supports PCIe 4.0 and 3.0 x4 lanes for solid-state storage expansion. Builders adding high-speed NVMe drives to compatible backplanes or enclosures will find it suitable.
Practical interface limits
The cable carries PCIe 4.0 or 3.0 x4 signals with a data rate up to 12Gbps per lane. Bandwidth is capped by the PCIe generation negotiated between host and device. Signal integrity over the 1.64FT run meets the Gen 4 specification without active components. No SATA or eSATA protocol is used on the high-speed pairs.
Setup checks before ordering
Verify that your motherboard or add-in card provides an Oculink SFF-8611 4i header. Confirm the target U.2 or U.3 drive accepts SFF-8639 input and that a SATA power source is available. Ensure the 1.64FT length fits your chassis routing without sharp bends. This cable does not convert M.2 or SATA drives to NVMe.
How it compares
Measured against everything we stock in SATA & eSATA Drive Cables, at today’s prices. Recalculated every night.
- Price $24.99
- Pricier than about 83% of the 1,954 comparable items (median $13.99).
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Specifications
No published specifications for this item yet.
Questions about this item
Which cable length should I choose for my build?
The cable is 1.64FT long; measure the distance between your Oculink host port and the U.2 or U.3 drive bay to confirm it reaches without strain.
What does the 12Gbps figure mean once the cable is installed?
It is the maximum data transfer rate the link can carry when both host and drive support PCIe 4.0 x4; actual throughput depends on the SSD and controller performance.
What interface standard does the SFF-8611 connector use and what does it cap?
The SFF-8611 end uses PCIe 4.0 x4, which caps the link at 12Gbps; it will fall back to PCIe 3.0 x4 if the host or drive only supports that generation.
More in SATA & eSATA Drive Cables
Similar items
STARTECH SATA6RA1 6" SATA right-angle cable 26 AWG 152.4 mm
- 6 in (15.2 cm)
- Cable Connectors
Nippon Labs SATA-1MR 1m right-angle SATA cable
- 3.28 ft (1m)
- SATA
OWC In-Line Digital Thermal Sensor SATA Cable Kit for iMac 27" 2012-2019
- SATA





